Every tool you need for a Toyota Tacoma oil change 2016 - 2022

2016 - 2022 TOYOTA TACOMA 3.5L V6 OIL SERVICE GUIDE Tools I prefer to use https://amzn.to/3L1XsSq The oil cap : https://amzn.to/4sjNxsz Engine size and configuration: 3.5L V-6 Engine oil capacity w/ filter change : 6.2 US qts w/ oil cooler, 6.1 US qts w/o oil cooler Engine oil viscosity (SAE): 0W20 Oil pan drain plug torque: 40 Nm / 30 ft lbs Oil filter cap torque: 25 Nm / 18 ft lbs Below you'll find a guide for changing your oil in a late model (2016-2022) Toyota Tacoma with a 3.5L V6 engine. Remove the lower engine cover. - Drain the engine oil into a container by removing the oil pan drain plug. - After the oil pan is drained, install the drain plug with a new gasket torquing to 40 Nm / 30 ft lbs. Remove oil filter cap drain plug from the oil filter cap and dispose of the old O-ring. - Install the Motivx Tools MX2341 drain tool into the oil filter cap by threading the hex portion of the tool into the bottom of the cap. - Direct the hose into the drain container and tighten the small hex nut on the tool to start the oil flow. The hose is intentionally long but can be cut to whatever length works best for you. - Once the oil filter cap is drained, remove the drain tool. - Install the Motivx Tools MX2320 oil filter wrench onto the oil filter cap and remove using either the 3/8" square drive or 24mm hex. - On over-tightened housings we recommend using a 6-point 24mm socket with a breaker bar - whatever length works best for you. - Remove and dispose of the used oil filter and O-ring from the cap. - Clean the inside of the oil filter cap including the threads and O-ring groove. - Lightly oil the new O-ring and install on the cap. Be sure it's installed in the O-ring groove as shown below. Install the new oil filter in the oil filter cap. Be sure the threads and sealing surface on the engine are clean, and hand thread the oil filter cap into the engine ensuring the O-ring seats properly. - Tighten the oil filter cap using the MX2320 oil filter wrench to 25 Nm / 18 ft lbs. - Lightly oil the new O-ring for the oil filter cap drain valve plug and install it in the groove shown below. Be sure the threads and sealing surface for the oil filter drain valve plug on the oil filter cap are clean and install the drain plug, torquing to 13 Nm / 10 ft lbs. - Refill the engine with the recommended amount and type of oil using a oil funnel and check the oil level. - Start the engine and inspect for leaks, then re-check and top off the oil as needed. - Install the lower engine cover #ad