How to Replace Transmission Fluid Drain & Fill Tacoma 2nd & 3rd Gen

🚨 Items needed below but read this first! *This video depicts the required and proper method to perform a temp check/fluid measuring after putting new fluid in. To perform a more complete drain and fill as well as change out the filter, see my other newer video then come back here* - New video: https://youtu.be/tFMy2CrWSQI 🛒Transmission Fluid - https://amzn.to/40wtg6A 🛒Crush Washers - https://amzn.to/4cOZTzN 🛒 Better Pump - https://amzn.to/3WZ0Org 🛒Old Pump - https://amzn.to/3TC4yyY 🛒10 Qt Measuring Bucket - https://amzn.to/48xrvYe 🛒 Hex Socket Set - https://amzn.to/46YQKDs 🛒1/2" Drive Socket Set - https://amzn.to/48Ao0Rb 🛒3/8" Drive Socket Set - https://amzn.to/41yyGNP 🛒3/8" Torque Wrench - https://amzn.to/41Bd7Mp (These are Amazon affiliate links: Amazon pays the channel a small fee every time you fine people buy through these links) 🚨Back this channel to support it's growth! https://www.youtube.com/channel/UCFztsO_RZhPbgGXqbu0ywbA/join 2020-2023 Tacomas see notes below! 💬Join the Discord: https://discord.gg/RUJbAj8QPB (comment if link broken) 🤜🤛Wanna do us the ultimate bro/bro'ette move? Send this video to a tacoma buddy! 🚨 Finally on IG! : @teamoildrop Notes: One user (zacharylechevalier202) reports they could get their 2020 Tacoma into temp check mode without a wire as their truck does not have a live connection in the OBD port 13. They just did the neutral drive back and forth. Furher explained by Toneloke1106: Just a heads up for people with the newer tacomas. It was already mentioned the OBD jump with pin 4 and 13 no longer works because 13 is dead. To get into temp mode I was having trouble until I saw a forum post that said you need to go from P to S back to P while sitting in these gear positions for ~3 seconds each BEFORE doing the back and forth between D and N. This got me into temp mode.