Peloton Screen Fix/Workaround: Get Your Unresponsive Bottom Touch Area Working Again

Is the bottom bar of your Peloton touch screen not working? Well here is a workaround to make the bike useable again! You'll need: Macbook USB C to USB C cable Disclaimer: This guide is intended solely for users who are out of warranty or have purchased their Peloton bike second-hand. I am not responsible for any damage or issues, including but not limited to breaking or bricking your Peloton bike, that may arise from following these instructions. If your Peloton bike is still under warranty, please contact Peloton support directly for assistance. Proceed at your own risk. Install instructions for Homebrew and Android Platform Tools: https://stackoverflow.com/questions/31374085/installing-adb-on-macos ChatGPT generated instructions (as a back up): 1. Install Homebrew (if not already installed) Open Terminal: Find it via Spotlight or in Applications - Utilities. Google how to install Homebrew Verify Installation: Run: brew -v to check that Homebrew is installed correctly. 2. Install Android Platform Tools via Homebrew Open Terminal: If not already open. Install Platform Tools: Run: brew install android-platform-tools Verify Installation: Run: adb version to check that ADB is installed and working. 3. Prepare Your Peloton Touch Screen Enable Developer Mode: Tap the top right corner of the Peloton screen to open the “About” menu. Tap 7 times on the "Build Number" to enable Developer Options. Enable USB Debugging: Go to Settings - Developer Options on the Peloton. Turn on “USB Debugging.” 4. Connect Your Peloton to Your MacBook Connect via USB: Use a USB cable to connect the Peloton touch screen to your MacBook. Authorize USB Debugging: Confirm the connection and allow USB debugging when prompted on the Peloton. 5. Use ADB to Adjust Screen Offset Open Terminal: Ensure ADB is accessible by typing adb commands directly. List Connected Devices: adb devices to ensure your Peloton is listed. Access Peloton Shell: adb shell to open a command shell on the Peloton device. Set the Offset: wm overscan 0,0,0,25 This sets the bottom offset to 25 pixels. REMEBER TO TURN OFF DEVELOPER MODE ON THE PELOTON BIKE ONCE YOU'RE HAPPY WITH THE RESULT!